Results 1 to 10 of 41

Thread: Model 19 Foams

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. July 8th, 2011, 03:50 PM #6
    Altec Best
    Altec Best is offline
    HB Super Moderator
    Model 19 Foams


    Altec Best's Avatar
    Join Date
    June 10th, 2008
    Location
    Central New Jersey
    Posts
    4,256
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    16 Post(s)

    Re: Model 19 Foams

    Quote Originally Posted by GM View Post
    Did you finally get your system finished?
    GM
    Yes, getting close,cabs damped,port tubes installed.I also installed a 2" dowel in the center of cab top to bottom.I'm at the point now where I have to start on the XO so I have to start taking measurements on the box.I have to get together with Pano on that though.

    The spring time is usually the stormiest.Now that we are heading into the July/August summer months hopefully the severe Tstorms will slow down a bit !

    I'll Keep in touch on the telephone then,until your computer issues are ironed out.Glad to hear that your Ok though, health wise !
    Last edited by Altec Best; July 8th, 2011 at 04:02 PM.

« Model 19's in Russia | replacement foam for Altec 19's »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

This forum has been viewed: 27936657 times.